OK
The Universal Selection Source:
Adhesives Ingredients
Industry News

Aremco's PYRO-PAINT ™ 634-AL Exhibits Exceptional Adhesion to Fiberboards

Published on 2011-07-22. Author : SpecialChem

Pyro-Paint™ 634-AL is a two-part, 99% alumina filled, ceramic coating system used to bond, coat and seal refractory fiber boards and other shapes used in molten metal fluid handling components and structures in foundry applications to 3200 °F (1760 °C). The advanced material helps to prevent wear and oxidation of refractory components and increases heat reflectivity to improve thermal efficiency and enable temperatures to ramp up more rapidly.

Pyro-Paint™ 634-AL is rated for temperatures up to 3200 °F (1760 °C) and exhibits exceptional adhesion to refractory fiberboards as well as alumina, graphite and ceramic cloth. Pyro-Paint™ is resistant to wetting by most molten metals, increasing the durability, erosion resistance and reliability of the underlying structure.

PYRO-PAINT™ 634-AL HIGH TEMP REFRACTORY COATING

Pyro-Paint™ 634-AL is formulated as a two-part system consisting of a liquid binder system and powder filler. Mix ratio is 3:1 powder to liquid by weight but this ratio can be modified to vary the viscosity. Mixed in a 3:1 ratio, the material has a solids content of 76.8% by weight and 66.0% by volume and a viscosity range of 5,000 to 6,000 cps. It is typically applied using a brush, roller or conventional spray equipment. Dry films from 2-3 mils up to 3/8" can be produced without cracking.

Pyro-Paint™ 634-AL is a simple to use, environmentally friendly, water-based formulation containing no volatile organic compounds. It dries at room temperature in several hours and cures fully within 2 hours at 200 °F.

Pyro-Paint™ 634-AL is part of a line of refractory coatings based on ceramic fillers including alumina-silica fibers, boron nitride, carbon, graphite, yttrium oxide, and zirconium oxide.

About Aremco

Formed in 1965, Aremco's advanced materials division has been a leader in the development and production of technical ceramics, adhesives, coatings, sealants and potting compounds for applications to 3200°F. These materials are used throughout industry in the design of sensors, electrical components and analytical instruments, as well as the maintenance and repair of high temperature process equipment.

Source: Aremco


Improve your performance with water soluble epoxy compounds
Back to Top