OK
The material selection platform
Adhesives Ingredients
The material selection platform
Adhesives Ingredients
Product News

DELO Launches Sealant for CMOS Image Sensors in Automotives

Published on 2024-05-14. Edited By : SpecialChem

TAGS:  Sealants    

DELO Launches Sealant for CMOS Image Sensors in Automotives DELO has developed DELO DUALBOND EG6290, a sealant adhesive for complementary metal oxide semiconductor (CMOS) image sensors, which are often used in driver monitoring systems. Glass filters can be bonded directly to the semiconductor chip using DELO DUALBOND EG6290.

Mechanically Consistent Behavior at High-temperatures


The electronics-specified adhesive can be dispensed in narrow, high bondlines, can compensate for temperature-dependent pressure changes, and meets routine automotive standards.

The new adhesive was specially designed for the glass-on-die assembly method. The glass filter is fixed directly onto the chip, as is typical with iBGA image sensor packaging.

DELO DUALBOND EG6290 has a high Young's modulus of 2,350 MPa and high adhesion value. Due to a glass transition temperature (Tg) of over +130 °C, the adhesive exhibits mechanically consistent behavior even at high application temperatures, for example, during the molding process and can compensate for temperature-dependent pressure changes.

Fulfills Requirements of AEC-Q100 Grade 2 Automotive Standard


DELO DUALBOND EG6290 thus fulfills the requirements of the AEC-Q100 Grade 2 automotive industry standard.

The adhesive is applied via needle dispensing. Due to its very high thixotropy index, narrow and high bondlines can be precisely dispensed, onto which the glass filter is then joined.

Curing takes place in two successive process steps, first, the adhesive is exposed to light with a wavelength of 365 or 400 nm. Then, as a result, the glass filter is fixed within a few seconds. The adhesive typically fully cures in 15 minutes at +130 °C. Due to the rapid curing reaction, the matrix in the adhesive builds up quickly, which ensures the image sensor package is reliably sealed.

Both the dual curing process and the comparatively low curing temperature help to minimize the pressure that usually occurs when bonding glass filters.

CMOS image sensors are essential components in modern vehicles and are installed, for example, in LiDAR and driver monitoring systems. They must be completely sealed to keep out dust and moisture and maintain their safety functions over their entire service life.

With this new product, DELO is expanding its portfolio of electronic adhesives, offering yet another solution for closed-cavity packaging in addition to adhesives for glass-on-housing applications. DELO DUALBOND EG6290 and other products developed for the microelectronics packaging sector will be presented at Semicon Southeast Asia, taking place from May 28–30, 2024 in Malaysia.

Source: DELO


Back to Top